How to Replace a Nissan Juke Spare Key
Nissan Juke is an attractive and enjoyable hatchback with distinctive engine configuration. It's quite noisy but still a blast to drive.
Replace the battery of the key fob of your Nissan Juke every two years, or when it's low. You can do it yourself, but you'll require some tools.
Dead Coin Battery
If the key fob of your Nissan Juke has stopped working, you should check the battery of your coin. It may be dead and require to be replaced. This is a straightforward fix that will take only about a couple of minutes. You can do this by flipping the fob over and accessing the tiny latch/release located on the back. Remove the battery from the old one and then insert a new one, making sure that it is facing down in the fob. Line up the two halves of the fob carefully.
If the fob was exposed to water, it will need to be cleaned prior putting the new battery in. Clean the fob by using isopropyl electronic cleaner and a paper towel. Then allow it to dry completely prior to reinstalling the battery.
To start the car, the key fob must also be paired to the car. This can be accomplished according to the instructions in your owner's guide or an OBDII scan. If the key fob is not been paired, this is the most likely reason of why it stopped functioning. A defective chip inside the fob can cause it to cease to function however, this is a rare. A new receiver module might be needed in this case. If this is the case, it will need to be replaced by an accredited technician.
Water Damage
Key fobs operate on batteries and the batteries need to be replaced every two years or at the point that the car stops responding when you push the "start" switch. Keys have rubber seals to keep water out, however submerging the key fob into the ocean or in a pool could damage the chip that is inside. If this happens you'll have to purchase the replacement key from Nissan or a locksmith.
If the key fob has a working chip It's likely that the computer has lost its connection to it, which can happen for any number of reasons. A simple restart of your car will resolve this issue, but should the key be showing the "Key ID" error message, it's best to contact Nissan or an auto locksmith for assistance.
Three typical causes are a dead battery on the key fob or a key that's not programmed, and a damaged key fob. The first two issues are simple to fix, while the third is more difficult to fix on the spot, but it is usually fixable with some patience. WhoCanFixMyCar lets you compare Nissan Key Replacement prices in your region and schedule your repair. Read reviews about local Nissan dealerships, Nissan mechanics, and garages in only a few moments.
Faulty Chip
The key fob of your Nissan Juke contains a special chip that sends a message to the vehicle whenever you turn it. The key might not function if the chip is faulty. If this happens, the problem will only be resolved by replacing the key. The Nissan Juke key could be defective for a variety of reasons, such as water damage or an inactive coin-battery.
Check the chip for water damage when your key fob stopped working after a bath or wash. Make sure that the metal retaining clips are tight and the chip isn't exposed to water. If you see any signs of water damage, consider removing the battery and wiping down the electronic component using isopropyl ethanol or electronic cleaner.
If nissan smart key replacement is damaged You'll need to contact your local locksmith or dealer. To find a replacement chip, they will need the year, model and year of your car. You'll also need to record your VIN (Vehicle ID Number) so that the dealer, or locksmith knows what key you have. This will allow them to verify the correct key code and ensure they are cutting the correct one.
Faulty Receiver Module
The key fob transmits an audio frequency signal to your car to perform various functions. It can open your trunk when you are rushing with groceries to your car or start your vehicle by pressing the fob's button. It can also open your windows and turn on the horn in case you have a mishap and lock your keys inside the car.
If the key fob doesn't work, it may be due to a problem in the receiver module. The receiver modules are tuned so they can receive certain frequencies that correspond to signals generated by Nissan key fobs. If your car has a faulty receiver module is damaged, it will cease to respond to any signal from the key fob.
Whatever the way your Nissan key fob ends up getting damaged, it is always beneficial to have a spare key in case the key gets lost or broken. A locksmith or dealer can program a spare key to work with your Nissan. This will allow you to avoid the hassles of losing your keys or locking them in your car.
If your Nissan Juke's key fob was exposed to rain or clean tap water, you can solve the problem by cleaning it with isopropyl or an electronic cleaner. If the chip has fried, you'll need to purchase an alternative keyfob that could be programmed for your vehicle by a dealer or locksmith.